Here are the instructions on how to reset the SecuRam SafeLogic to factory settings.
|The following procedure will ERASE all codes in your lock. If not followed correctly you could cause your lock to no longer function properly. It is best to have a Safe Retailer or Locksmith come out and perform these for you. If you are local here in Oklahoma give us a call to scheduled a service call and we will be happy to come out and perform this for you!
These instructions will remove all codes from your lock, this may affect your safe warranty please check with your safe manufacture for any warranty questions.
Lock It Up Safes is not responsible for any outcome that may come up while performing this procedure.
|Step 1||Unlock your safe and turn your safe handle so that the bolts/bars are open|
|Step 2||Remove the door panel to your safe|
|Step 3||Locate the reset hole on the back of the lock (Very Small Hole)|
|Step 4||Unplug the white Communication wire on the top of the lock|
|Step 5||With a paperclip insert the clip into the hole marked reset, push it in about 3 or 4 times|
|Step 6||With the paperclip fully pushed in, plug in the white communication wire to the top of the lock the lock will begin to beep|
|Step 7||Remove the paperclip. You lock is now fully factory reset with a Admin Code of 1 1 1 1 1 1 and a User Code of 1 2 3 4 5 6|
|Step 8||Test the default lock code and also check to ensure the bolts/bars retract into the safe properly.|
|Changing the lock code|
|KEEP YOUR SAFE DOOR OPEN FOR THE ENTIRE PROCEDURE
MAKE SURE YOUR NEW CODES WORK BEFORE CLOSING THE DOOR
THE SAFE BOLTS / BARS SHOULD BE EXTENDED DURING THE LOCK CHANGING PROCEDURE
|Step 1||Enter 0 0 0 0 0 0 (zero six times)|
|Step 2||Enter 1 1 1 1 1 1 (one six times)|
|Step 3||Enter new six digit admin code|
|Step 4||Enter new six digit admin code|
|Step 5||Admin Code is now changed|
|Step 6||Enter 0 0 0 0 0 0 (zero six times)|
|Step 7||Enter 1 2 3 4 5 6|
|Step 8||Enter new six digit User Code (CANNOT BE SAME AS ADMIN CODE)|
|Step 9||Enter new six digit User Code|
|Step 10||User Code is now changed|
|Step 11||Test your new codes BEFORE CLOSING THE SAFE DOOR|
|Step 12||TEST CODES BEFORE CLOSING DOOR|